The set of hemmers, The set of hemmers g – SINGER W426 User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THE SET OF HEMMERS
Before attaching any of the hemmers, be sure bobbin thread is pulled up.
Then, with hemmer in place, hold top thread loosely
and turn
handwheel
one
full
turn
toward
you,
making
a
loop
under
hemmer. Grasp bobbin thread with both hands and slip horizontally under hemmer
toward back. Bobbin thread, will catch loop and carry upper thread to back of
hemmer.
Fold material to suit for two inches along edge, hold at each end of fold. Slip fold
into guide and up over spoon. Fold hem in material back of hemmer. Draw forward
to end of hem and fasten with point of needle. Pull on threads gently as you start
stitching.
1
If
i
' !if0.
You can make a hem 1/4", 3/8", 5/8" or 7/8" in width, depending upon which
hemmer you use. A few uses are shown below.