Preparing to sew, Removing the work – SINGER W951 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

PREPARING TO SEW

Have take-up lever at highest point before starting to sew. Do not try to help the feeding by pulling the material

as this may deflect the needle and cause it to break.

NEVER run machine without material under presser foot.
Place material and threads in position under the presser foot and lower the presser foot. You are now ready to

begin sewing. By having the needle at its highest point, it is not necesary to touch the hand wheel to start the

machine. You merely press the control. The speed of the machine is regulated by increasing or decreasing the amount

of pressure exerted on the control.

REMOVING THE WORK

Be sure to stop the machine when

the thread take-up lever and needle bar
are at the highest position.

Now raise the presser foot and

draw the fabric back and to the left

{Fig. 17, A and B) and pass the threads

over the thread cutter.

Pull down slightly, holding thread

in both hands,

k

) as not to bend the

needle.

Leave the ends of thread under the

prefer foot.

Fig. 17A

Fig. 17B

- 11

Advertising