How to change the belt – SINGER W951 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HOW TO CHANGE THE BELT
If it should ever become necessary to replace the belt on your machine,
proceed as follows:
(1) Remove screws "A" I Fig. 68)
(2) Remove rear cover.
(3) Remove stop motion knob "B" in center of hand wheel (Fig.68) by taking
out small screw "C”. Turn nut counter-clockwise by holding the take-up
lever until it can be lifted off.
(4) Before moving hand wheel, note position of lips on washer " D " (Fig. 69)
as it will fall off when changing the belt.
(5) Slide old belt over motor pulley
"E" (Fig. 69).
(6)
Pull hand wheel awray from ma
chine just far enough to allow the
belt to slip over wheel.
(7) Put new belt in grooved action of
hand wheel and then over motor
pulley.
(8)
Replace washer D in original
position.
(9) Replace stop motion and s:rew "C".
After doing this, turn clutch toward
you to disengage sewing mecha
nism. If the needle still moves up
and down as you turn the hand
wheel, again remove the stop
motion, give washer "D" a half turn
and replace the nut.
(10) Replace rear cover.
Fig. 68
30
Fig. 70