Adjusting pressure and feeding of fabric, Sewing thin or light weight fabrics, Darning and mending – SINGER W951 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADJUSTING PRESSURE AND FEEDING OF FABRIC
GENERAL SEWING. Usually for straight sewing and various embroidery work, the pressure bar cap or darning release
(Fig. 27) is at its lowest position and the feed at its highest level-with the drop feed button marked UP pressed all the all the
way down {Fig. 27)
SEWING THIN OR LIGHT WEIGHT FABRICS
When lighter pressure is required to sew satisfactorily on thin
silk or flimsy material, the pressure bar cap should be about
halfway down.
Release all the way by preying the snap lock ring "A'
(Fig. 28) and then press cap "B" down to the half-way spot.
Turn drop feed knob "C" (Fig. 26) to the low position.
DOWN
M l O H I
L O W ______J
Fig. 26
DARNING AND MENDING
In order to move the fabric freely in any direction for darning,
mending or monograming, release the presser bar cap B
(Fig. 28) completely by pressing down on the snap lock "A".
Turn drop feed knob to down position which drops the fe»i
well below the needle plate.
Fig. 27
14