Setting the needle – SINGER W951 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Fig. 3
Fig. 4
See Fig. 3. Raise the needle bar "A" to its highest
point, turning wheel toward you by hand (Fig. 4).
Then loosen the needle clanrip screw "B" and the
needle can be insert«! into clamp "C". Place needle (flat
side to back) in the needle clamp and push it upward as far
as it will go into the needle clamp hole, tightening the
ne«ile clamp screw securely.
Aft«- Changing die needle make one «»mplete
revolution of hand wheel by hand to be sure the needle is
in the correct position.
SETTING THE NEEDLE
FLAT
SIDE OF
NEEDLE
Fig. 5
,, you onoounter an, prob,an,s „i,h your ™d,in. after cbangin, ,be n»<«a such as puckering, skipped stitches, or
needle and thread breakage, check the following:
,
(1)
Is the needle up as far as it will go into the clamp?
(2)
Is the flat side to the back ?
(3)
Is the needle the right size for the thread used ?
(4)
Have you tightened the clamp securely ?
(5)
Is the needle bent or the point blunt?