Datalogic Scanning Jet - Manual (Page 19)

INTRODUCTION
3
1
1.4 INSERTING MINI SD CARD
With Datalogic Jet™ PDA, it is possible to add a Mini SD Card for
additional
storage capacity. To access the Mini SD card slot, unscrew the cover at the side of
Datalogic Jet (see Figure A) and then proceed as follows:
1. Before inserting the Mini SD card, peel the adhesive pull tab and stick it onto to
the Mini SD card as shown in the picture below:
2. Open the Mini SD card slot by unscrewing the two screws:
3. Insert the card with the written part upward and push it until it clicks into place:
To remove the Mini SD card slightly push it toward the inside until it clicks; the card is
released, pull it out using the adhesive pull tab.