Datalogic Scanning Jet - Manual (Page 38)

DATALOGIC JET™
3
3.3.2 Imager Data Capture
To read a 1D or 2D code, simply point the Datalogic Jet™ Imager model onto the
code from a distance within the reading range (see par. 5.1, section Datalogic Jet™
Imager Optical Features) and press one of the three SCAN Keys.
The Datalogic Jet™ Imager uses an intelligent aiming system pattern, similar to
those on cameras, indicating the field of view, which should be positioned over the
code:
Aiming System
If the aiming system pattern is centered over the entire symbology as shown in the
following figure, either wait for the timeout or release the Scan key to capture the
image.
A red beam illuminates the code, which is captured and decoded. You will get a good
read.
22