ADLINK PXES-2780 - Manual (Page 38)

28 Getting Started
2.4.1 Powering Up the System
The PXES-2780 is equipped with a 100 VAC to 240 VAC universal
power supply unit requiring no input voltage selection.
1. Connect one end of the supplied power cord to the
power inlet located at the rear side of the chassis.
2. Plug the other end of the AC power cord to a properly
grounded wall socket or power strip.
3. Press the standby power switch. The Power LED (blue)
lights up immediately
4. To power off the chassis, press the standby power
switch.
PRELIMINARY