ADLINK PXES-2780 - Manual (Page 49)

Troubleshooting and Maintenance 39
PXES-2780
Appendix A - Troubleshooting and Mainte-
nance
This Appendix describes basic troubleshooting techniques, as well
as instructions for the maintenance of the PXES-2780 chassis.
A.1 Installation Problems
Inability to start the system frequently results from incorrect instal-
lation of the system controller, peripheral modules, and other com-
ponents. Before starting the system, please ensure that:
X
The system controller is properly installed and secured
X
All peripheral modules are properly seated on the slots
X
All cables are properly connected to the system controller
and peripheral modules
X
All installed peripheral modules are compatible for use in
the chassis
X The power cord is securely plugged into the chassis power
connector and power outlet/wall socket/power strip
If the system fails to start when all installation conditions are met,
remove all installed peripheral modules and try again. If the sys-
tem starts normally, install one peripheral module at a time fol-
lowed by powering up. You may also try installing the modules into
different slots until the desired result is obtained.
PRELIMINARY