ADLINK PXES-2780 - Manual (Page 45)

System Management & Configuration 35
PXES-2780
Figure 3-3: PXI Trigger Routing Interface
PXIe Link
Displays PCI express switch fabric settings fir the PXES-2780
backplane.
Selecting required configuration (4Link x4 or 2Link x8) and
Config applies new settings.
Target Temperature
When the Fan switch on the rear panel is set to AUTO, fans run
at different speeds based on the measured temperature.
Target Temp indicates the temperature at which fans run at
100%. Using the default 50°C as an example, fans run at 40%
when all temperature readings are less than 25°C, and begin
rampup when any reading exceeds 25°C.
NOTE: NOTE:
The new setting will not be valid until system is restarted.
PRELIMINARY