ADLINK ND-6520 - Manual (Page 22)

18 • NuDAM-6520
2.3. Installation
Software Utility
Software is not necessary for this module.
Equipments for Installation
A host computer with RS-232 port
RS-232 cable (DB-9 female)
DC Power supply (+10V~+30V) (NDP-243u is recommended)
Wires (shielded and grounded is recommended)
Installation Procedure
1. Make sure the host computer is power off.
2. Use RS-232 cable to connect NuDAM-6520 with host computer.
3. Wire the power supply to NuDAM. Note that the power supply should meet
the specification.
4. Wire other NuDAMs.
Application Wiring
The Figure 2-1 shows the application wiring of NuDAM-6520.
Figure 2-1 Application wiring of NuDAM-6520
Host
Computer
DATA +
DATA -
+Vs GND
+ DATA
- DATA
+Vs GND
Local Power Supply
+10 V to +30 V
+Vs GND
NuDAM
module NuDAM-6520
RS-232/RS-485
Converter
RS-232