ADLINK aTCA-6200A - Manual (Page 38)

38
4.3 IPMI Commands
The following table presents all the commands which are supported by the aTCA-6200 in different
interfaces and that are compatible with IPMI v1.5 and PICMG 3.0 R2.0 ECN001. There are two
interfaces implemented with IPMI command support.
1. KCS: OpenIpmi
2. IPMB0: IPMBa & IPMBb
KCS IPMB0
IPMI commands
IPM Device “Global” Commands
Get Device ID ● ●
Cold Reset ● ●
Warm Reset ● ●
Get Self Test Results
● ●
Get Device GUID ● ●
IPMI Messaging Support Commands
Set BMC Global Enables
● ●
Get BMC Global Enables ● ●
Clear Message Flags ● ●
Get Message Flags ● ●
Get Message
● ●
Send Message ● ●
Master Write-Read ● ●
BMC Watchdog Timer
Reset Watchdog Timer ● ●
Set Watchdog Timer ● ●
Get Watchdog Timer ● ●
Event Commands
Set Event Receiver ● ●
Get Event Receiver ● ●
Platform Event
● ●
Sensor Device Commands
Get Device SDR Info ● ●
Get Device SDR
● ●
Reserve Device SDR
Repository
● ●
Get Sensor Reading Factors
● ●
Set Sensor Hysteresis
● ●
Get Sensor Hysteresis ● ●
Set Sensor Threshold ● ●
Get Sensor Threshold
● ●
Set Sensor Event Enable ● ●
Get Sensor Event Enable ● ●
Rearm Sensor Events
● ●
Get Sensor Event Status
● ●
Get Sensor Reading ● ●