ADLINK cPCI-6210 - Manual (Page 113)

BIOS Setup Utility 99
cPCI-6210
Communication with slow devices may require more than 1
stop bit. Set this value to 1 or 2.
Flow Control
Set this option to select Flow Control for console redirection.
The settings for this value are Noneand Hardware RTS/CTS.
Flow control can prevent data loss from buffer overflow. When
sending data, if the receiving buffers are full, a 'stop' signal can
be sent to stop the data flow. Once the buffers are empty, a
'start' signal can be sent to re-start the flow. Hardware flow con-
trol uses two wires to send start/stop signals. Software flow
control uses start/stop ASCII chars, which slows down the data
flow and can be problematic if binary data is being sent.
Recorder Mode
When enabled, only text will be sent. This is to capture terminal
data.
Resolution 100x31
Enables or disables extended terminal resolution.
Legacy OS Redirection Resolution
In legacy OSes, the number of rows and columns supported by
redirection. The settings for this value are: 80x24, 80x25.