ADLINK cPCI-6210 - Manual (Page 72)

58 Getting Started
4. Align the drive assembly so that the connector on the
DB-6920SAT mates with the board-to-board connector
(CN12) on the cPCI-6210 as shown. Press down on the
DB-6920SAT until it is properly seated.
5. Secure the top side of the drive assembly with two
screws shown as below. Turn the board over (solder side
up) to continue securing the drive assembly.
CAUTION:
Support the hard drive assembly to avoid damaging the SATA
connectors when turning the board over to proceed with Step 6.