ADLINK cPCI-6210 - Manual (Page 128)

114 IPMI User Guide
Set Sensor Event
Enable
35.10 S/E 28h
This command provides the ability to
disable or enable Event Message
Generation for individual sensor events.
The command is also used to enable or
disable sensors in their entirety using the
disable scanning bit. (Optional/Optional)
Get Sensor Event
Enable
35.11 S/E 29h
This command returns the enabled/
disabled state for Event Message
Generation from the selected sensor. The
command also returns the enabled/
disabled state for scanning on the sensor.
(Optional/Optional)
Get Sensor Event
Status
35.13 S/E 2Bh
The Get Sensor Event Status command
is provided to support systems where
sensor polling is used in addition to,
or instead of, Event Messages for event
detection. (Optional/Optional)
Get Sensor
Reading
35.14 S/E 2Dh
This command returns the present
reading for sensor. The sensor device
may return a stored version of a
periodically updated reading, or the
sensor device may scan to obtain the
reading after receiving the request.
(Mandatory/Optional)
Get Sensor Type 35.16 S/E 2Fh
This command is used to assign the
Sensor Type and Event/Reading Type to
a specified sensor. (Optional/Optional)
FRU Device Commands
Get FRU Inventory
Area Info
34.1
Stora
ge
10h
Returns overall the size of the FRU
Inventory Area in this device, in bytes.
(Mandatory/Optional)
Read FRU Data 34.2
Stora
ge
11h
The command returns the specified data
from the FRU Inventory Info area.
(Mandatory/Optional)
Write FRU Data 34.3
Stora
ge
12h
The command writes the specified byte
or word to the FRU Inventory Info area.
(Mandatory/Optional)
Command
IPMI
Spec
NetFn CMD
Description
(Required by PICMG 3.0/2.9)