ADLINK cPCI-6210 - Manual (Page 127)

IPMI User Guide 113
cPCI-6210
Get Event Receiver 29.2 S/E 01h
This global command is used to retrieve
the present setting for the Event Receiver
Slave Address and LUN. This command
is only applicable to management
controllers that act as IPMB Event
Generators. (Mandatory/Optional)
Platform Event
Message
29.3 S/E 02h
This command may be thought of as a
request for the BMC to process the event
data that the command contains.
Typically, the data will be logged to the
System Event Log (SEL).
(Mandatory/Optional)
Sensor Device Commands
Get Device SDR
Info
35.2 S/E 20h
This command returns general
information about the collection of
sensors in a Dynamic Sensor Device.
(Mandatory/Optional)
Get Device SDR 35.3 S/E 21h
The ‘Get Device SDR’ command allows
SDR information for sensors for a Sensor
Device (typically implemented in a
satellite management controller) to be
returned. (Mandatory/Optional)
Reserve Device
SDR Repository
35.4 S/E 22h
This command is used to obtain a
Reservation ID. (Mandatory/Optional)
Set Sensor
Hysteresis
35.6 S/E 24h
This command provides a mechanism for
setting the hysteresis values associated
with the thresholds of a sensor
that has threshold based event
generation. (Optional/Optional)
Get Sensor
Hysteresis
35.7 S/E 25h
This command retrieves the present
hysteresis values for the specified
sensor. (Optional/Optional)
Set Sensor
Threshold
35.8 S/E 26h
This command is used to set the
specified threshold for the given sensor.
(Optional/Optional)
Get Sensor
Threshold
35.9 S/E 27h
This command retrieves the threshold for
the given sensor. (Optional/Optional)
Command
IPMI
Spec
NetFn CMD
Description
(Required by PICMG 3.0/2.9)