ADLINK cPCI-6210 - Manual (Page 61)

Board Interfaces 47
cPCI-6210
Mode Switch (SW6)
Switch SW6 is a multi purpose switch that allows users to
define the board operating mode. Four pins independently con-
trol the mode setting. All are set to OFF by default.
Table 4-24: Mode Switch Settings
Pin# Status Description
1
OFF Not used.
ON Not used.
2
OFF
When the system does not include a CMM (Chassis
Management Module), set this pin to OFF to allow IPMI to run in
"without CMM mode".
ON
When the system includes a CMM, set this pin to ON to allow
IPMI to run in "with CMM mode".
3 OFF For debugging purposes. Do not change the default setting (OFF).
4
OFF
The cPCI-6210 power on/off is state is controlled by the ejector
handle state.
ON Force the ejector handle state to "closed".
ON
1 2 3 4