ADLINK cExpress-HL - Manual (Page 29)

cExpress-HL Page 29
Signal Pin Description I/O PU/PD Comment
PEG_TX15+
PEG_TX15- D101
D102
PEG_LANE_RV# D54 PCI Express Graphics lane reversal input strap.
Pull low on the Carrier board to reverse lane order. I 1.05V Not supported
3.4.6 Module Type Definition
Signal Pin # Description I/O Comment
TYPE0#
TYPE1#
TYPE2# C54
C57
D57 The TYPE pins indicate to the Carrier Board the Pin-out Type that is implemented
on the module. The pins are tied on the module to either ground (GND) or are no-
connects (NC). For Pinout Type 1, these pins are don’t care (X).
TYPE2# TYPE1# TYPE0#
X X X Pinout Type 1
NC NC NC Pinout Type 2
NC NC GND Pinout Type 3 (no IDE)
NC GND NC Pinout Type 4 (no PCI)
NC GND GND Pinout Type 5 (no IDE, no PCI)
GND NC NC Pinout Type 6 (no IDE, no PCI)
The Carrier Board should implement combinatorial logic that monitors the module
TYPE pins and keeps power off (e.g deactivates the ATX_ON signal for an ATX
power supply) if an incompatible module pin-out type is detected. The Carrier
Board logic may also implement a fault indicator such as an LED.
Type 6
3.4.7 Power and Ground
Signal Pin # Description I/O PU/PD Comment
VCC_12V C104-C109
D104-D109
Primary power input: +12V nominal (5 ~ 20V wide input).
All available VCC_12V pins on the connector(s) shall be used. P 5~20 V
GND C1, C11, C21, C31, C41,
C51, C60, C70, C76, C80,
C84, C87, C90, C93, C96,
C100, C103, C110, D1,
D11, D21, D31, D41, D51,
D60, D67, D70, D76, D80,
D84, D87, D90, D93, D96,
D100, D103, D110 Ground - DC power and signal and AC signal return path.
All available GND connector pins shall be used and tied to carrier
board GND plane.
P