Dream Property DM500 HD - Manual (Page 13)

-13-
2. Installation
2.1 Turning the device on
• Place the batteries inside the battery compartment of the remote control keeping in mind the right polarity.
• Before using the Dreambox, please read the safety instructions (See chapter 1.1 Safety instructions)
• Connect the LNB or antenna with a coaxial cable to LNB in at your Dreambox.
See chapter 1.3.2 Explanation rear panel.
• Connect the Dreambox to your TV using a HDMI- or Scart-cable.
• Plug in the power cable into the power supply and into a 110V/60Hz or 230V/50Hz power socket. Con
nect the power supply with your Dreambox.
• If you are using a switchable power socket please shutdown your Dreambox into deep standby before
switching off the power socket. See chapter 4.1 Turning your Dreambox on and off.
• If you switch on your Dreambox for the first time, you will see the setup wizard.
The setup wizard will guide you through the first time installation. Follow the instructions on the screen.
See chapter 3. Start wizard.
• Please note that the factory setting for the video format is CVBS (FBAS).