Dream Property DM500 HD - Manual (Page 36)

-36-
7.2.2 Stop recording
7.2.3 Recording by timer
With the help of a timer you can record shows. You are offered two different ways to program a timer, the
manual way of via the EPG.
If no OSD menu is visible on your screen, press the Menu-Button to open the main OSD menu. Navigate to
the option “Timer” and press the OK-Button to select.
You see the “Timer Editor“ menu.
Pressing the red Options-Button will delete a timer. The green
Options-Button adds a timer, the yellow Options-Button toggles
active on and off (only possible in waiting status) and the blue
Options-
Button removes finished timers from the list.
To edit an existing time select it and press the OK-Button .
The status of a timer is shown on the right side:
- waiting means: still coming up
- recording means : recording right now
- done means : recording finished
- the red X indicates that a timer was deactivated
Switch to the service which recording you want to stop.
Press the red Options-Button , select the "Stop recording" option
and press the OK-Button to select.
If you only have one active recording it will be stopped immediate-
ly.
If more than one recording is active you will given the choice
which recording you want to stop.
If you pressed the blue Options-Button you will be asked if you
really want to delete the finished timer.
Use the Navigation-Buttons up and down to select.
Press the OK-Button to activate.
Your Dreambox will be turned on 5 minutes before the recording if a recording is supposed to start while the
Dreambox is in Deep-Standby mode.
Note: If your Dreambox is in Deep-Standby mode no timer recordings will be possible.