Dream Property DM500 HD - Manual (Page 49)

-49-
AC3 downmix:
If you’re watching a show with a AC3 audio track it will be changed into a stereo signal. Set this option to
“yes” if your have an AV-Receiver that does not support Dolby Digital.
General AC3 Delay:
Using this option you can set a delay for the AC3 signal. This is useful if the AC3 sound is heard too soon or
too late compared to the video on the screen. The set value will be used for all services. Using the
Navigati-
on-Buttons left/right you can set the delay in 25ms increments.
General PCM Delay:
Using this option you can set a delay for the PCM signal. This is useful if the PCM sound is heard too soon or
too late compared to the video on the screen. The set value will be used for all services. Using the
Navigati-
on-Buttons left/right you can set the delay in 25ms increments.
OSD visbility:
Use the Navigation-Buttons left/right to set the transparency of the OSD.
Scaler sharpness:
Using the Navigation-Buttons left/right you can adjust the sharpness of the picture.
These options are only available if the output type is set to “Scart”:
Mode:
Scart
Select the standard supported by your TV screen. This is usually either PAL or NTSC. If you own a TV screen
which supports both modes you can also select the Multi option. You TV screen will automatically switch
depending on the input signal. These options are only available ifthe output type is set to “Scart”.
Aspect ratio:
Automatic (Standard)
4:3 shows will be shown as 4:3 and 16:9 shows will be shown as 16:9.
4:3
Display 16:9 content as:
Letterbox
16:9 programs will be displayed on 4:3 TV’s with black beams at top and bottom.
Pan&Scan
16:9 programs will be zoomed to full hight on 4:3 TV’s, parts of the picture on the left and right side will cut
off.
Just Scale
4:3 shows will be shown in full height on a 16:9 screen and are stretched to fit the width of your screen.
16:9 und 16:10:
Display 4:3 content as:
Please see previous page.