Dream Property DM500 HD - Manual (Page 8)

-8-
1.3.1 Explanation Front Panel
Smartcard reader
Insert your Dreamcrypt Smartcard with the golden chip facing down and forward into one of the two Smart-
card reader slots. Dreamcrypt is a registered trademark of Dream-Multimedia.
Standby-LEDs
One red and one green LED show the standby status of your Dreambox.
Remote control sensor
The remote control sensor receives the infrared signals of the Dream Remote Control.
Standby-Button
The Standby-Button switches your Dreambox on and off.
1.3.2 Explanation rear panel
LNB-Input (DVB-S2 Tuner)
Connect the coaxial cable from your LNB here.
Service port
The mini-USB Service port is used to update the operating system and to pre-programm you Dreambox using
a PC.
TV Scart output
Connect your TV, projector or beamer to your Dreambox using a Scart cable.
eSATA connector
You can connect an external eSATA Hard disk.
Digital audio out (Toslink)
You can connect your Dreambox with an optical (Toslink) cable to your HiFi-Amplifier or DSP. The AC3 signal
is also available at this port in case the selected channel transmits Dolby Digital signals.
HDMI output
Use the HDMI cable to connect the HDMI output to the HDMI input of your TV.
Power Switch
The power switch is used to cut all power from your Dreambox.
Network interface
The 10/100Mbit Ethternet port is used to communicate with your Dreambox via HTTP, FTP, NFS, Telnet,
SSH and Samba. This port is also used to update the operating system of your Dreambox. Please use a regu-
lar patch cable to connect your Dreambox to your LAN.
Modem port
The modem port can be used to establish an internet connection using a analog phone line.
Power supply connector
Plug the power cable of the power supply that came with your Dreambox into power outlet. Connect your
power supply to your Dreambox. You must not connect the power plug of the power supply to anything other
than a socket that supplies 110V/60Hz or 230V/50Hz.