Start wizard, 1 video output selection – Dream Property DM500 HD User Manual
Page 14
-14-
Finally you can adjust the screen using some test screens.
Select your desired option with the
Navigation-Buttons up
and
down
. Press the
OK-Button
to activate.
The video output should now be configured.
3. Start wizard
The start wizard helps you with the basic setup of your Dreambox.
3.1 Video output selection
You will be shown different video output modes for roughly 10 seconds, after you have connected and swit-
ched on your Dreambox. Once you see a clear picture on your TV screen press the
OK-Button
to select it. If
you prefer a different output than the selected one you can use the
Navigations-Buttons up/down
and the
OK-Button
to select it.
You can choose from the following video output options:
1.
HDMI
using a HDMI cable
2.
Scart
using a Scart cable
Select your desired option with the
Navigation-Buttons
up and
down. Press the
OK-Button
to activate.
You are taken to the next step.
You can now select the video mode.
The possible options strongly depend on the video output mode
you have selected in the step before. To learn more about the op-
tions refer to chapter 10.4 A/V Settings.
Select your desired option with the
Navigation-Buttons
up and
down. Press the
OK-Button
to activate.
You are taken to the next step.