Dream Property DM500 HD - Manual (Page 55)

-55-
For Port A and Port B select the desired satellites just as described
in the Single satellite – direct connection section.
Make sure you know which satellite is connected to which input on
the Toneburst switch. If you do not find any services in the trans-
ponder scan later, exchange the two satellites in this list and try
again.
Press the OK-Button to save your settings.
If you have trouble with “Tune failed“ messages please set the
“Send DiSEqC only on sattelite change“ and “Set voltage and
22KHz“ to “yes“.
11.1.4 Four satellites via DiSEqC A/B/C/D
Use this type of configuration if you want to receive four satellites from one Single Universal or Twin Universal
LNB for four or eight parties. It does not matter if you use one or two dishes to achieve this.
In this case the LNBs are connected to a so-called Multiswitch from which the signal is via coax cabled to the
satellite receivers (Dreamboxes) in your household.
Please read the section 11.1 DVB-S2 configuration to learn how to get into this menu.
Four satellites via DiSEqC A/B/C/D (DVB-S)
The Reception settings menu will open up.
Use the up/down-Buttons to navigate to the
Mode option and use the left/right-
Buttons to select DiSEqC A/B/C/D.
For Ports A, B, C and D select the desired satellites just as descri-
bed in the Single satellite – direct connection section.
Make sure you know which satellite is connected to which input on
the Toneburst switch.
If you do not find any services in the transponder scan later, ex-
change the two satellites in this list and try again.
Press the OK-Button to save your settings.