Labconco Protector Controlled Atmosphere Glove Box - Manual (Page 55)

Chapter 7: Accessorizing Your Glove Box
Product Service 1-800-522-7658 51
5. Electrical Power Strips
These convenience electrical power strips are available in US and
international versions and plug into the interior receptacle of the
glove box.
Part # Descriptions
5211500 US Power Strip 115V, 4 Position, 10A
5210601 UK Power Strip 250V, 6 Position, 10A
5290401 European Power Strip 250V, 4 Position, 10A
5332601 Australian Power Strip 250V, 6 Position, 10A
6. Electrical 9 Pin Sealed Pass-Through Kit (Part #5075619)
Includes sealed 9 pin (D-subminiature with male pins on one side and
female pins on the other) connector and cord for data transfer outside
the glove box. Typical data transfer includes oxygen/moisture levels
or analytical balance measurements to a printer.
7. Gas Inlet / Vacuum Outlet Tubing Kits and Direct Drive Vacuum
Pumps
These flexible vinyl tubing kits provide the necessary tubing and
fittings to make connections to an inert gas supply tank and a rotary
vane vacuum pump. See Figures 3-4 and 3-7.
Part # Descriptions Used With
5245100 Complete Gas/Vac Tubing Kit (Required) Manual Valves, all Protector Glove Boxes
5245200 Complete Gas/Vac Tubing Kit (Accessory) Auto Pressure Controller, accessory only
1472100 Direct Drive Vacuum Pump, 115V, 50/60Hz All Glove Boxes
7739400 Direct Drive Vacuum Pump, 230V, 50/60Hz,
NEMA 6-15P plug All Glove Boxes, International Version
7739402 Direct Drive Vacuum Pump, 230V, 50/60Hz
with reverse IEC plug All Glove Boxes, International Version
8. AtmosPure Re-Gen Gas Purifiers (see catalog #’s below)
The AtmosPure Re-Gen Purifier produces an ultrapure inert
atmosphere for materials sensitive to moisture and/or oxygen by
circulating an inert gas and removing oxygen and moisture inside the
box. Compatible with any Protector or Precise Controlled
Atmosphere Glove Box, the AtmosPure allows the boxes to meet or
exceed ISO 10648-2 test methods. The Purifier has the capacity to
remove up to five liters of oxygen (13,500 ppm) and 660 grams of
moisture (18 million ppm) at standard temperature and pressure
(STP). Depending on the application, glove box liner material and
frequency of use, regeneration may be necessary only once every one
to three months and completed in only 13 hours. See Figure 1-1 in
Chapter 1.