Labconco Protector Filtered Glove Box User Manual
Page 17
Product Service 1-800-522-7658
13
C
C
h
h
a
a
p
p
t
t
e
e
r
r
3
3
:
:
G
G
e
e
t
t
t
t
i
i
n
n
g
g
S
S
t
t
a
a
r
r
t
t
e
e
d
d
Once the site for your Protector Glove Box is properly prepared, you are
ready to unpack, inspect, install, and validate your system. Read this chapter
to learn how to:
• Unpack and move the glove box.
• Set up the glove box with the proper supporting structure and work
surface.
• Connect to an exhaust system if applicable.
• Install the gloves.
• Connect the electrical supply.
• Set the exhaust volume with the speed control adjustment.
• Reset the calibration program if applicable.
• Arrange validation for the glove box.
Each Protector Glove Box weighs 350 lbs. (158 kg) for
fiberglass models, 500 lbs. (225 kg) for single width stainless
steel models, and 1000 lbs. (450 kg) for double width
stainless steel models. The shipping container allows for
lifting with a mechanical lift truck or floor jack. If you must
lift the enclosure manually, follow safe-lifting guidelines. Do
not lift by the upper sheet metal façade and front panel as
damage can occur.
!