Laerdal SimMan 3G Trauma - Manual (Page 18)

18
SETUP
Fill Internal Blood Reservoir
1 Roll the right leg skin down to expose the fill panel.
2 Connect blood fill unit tubes to the blood and air connectors
in the right leg panel.
3 Push the fill button on the panel. The button will light up and
blood will flow into the Patient Simulator.
4 When the flow stops, disconnect the fill unit.
5 Push the fill button on the panel. The light will go out.
Note: Disconnect tubes from the Patient Simulator before pushing
the fill button. Pushing the button before disconnecting the tubes
will initiate draining of the tank.
Empty Internal Blood Reservoir
1 Connect an empty blood fill unit to blood connector
in the right leg panel.
2 Blood from the internal reservoir will drain into the bottle.
3 When the flow stops, disconnect the blood connector.
Mixing of Blood and Fluid
To simulate clear fluids and secretions: Fill the Fluid Fill Unit with
de-ionized water (approx
3 /
4
full) only and tighten the cap.
To mix simulated blood: Fill the Blood Fill Unit with de-ionized water.
Add 5-10 drops of Laerdal Blood colored concentrate, mix and
tighten the cap.
Run Patient Simulator with External Blood
1 Drain the internal reservoir. Follow instructions for “Empty
Internal Blood Reservoir”.
2 After draining the internal reservoir, fill the blood fill unit and
connect to the Patient Simulator.
3 Push the fill button on the panel. The button will light and blood
will flow into the Patient Simulator.
4 Charge the system for 60 seconds before starting bleeding
simulation.
Warning: Connecting a full blood fill unit to a Patient Simulator with
a full internal reservoir will result in system overflow. Blood will
drain out of the right leg. Repeatedly overflowing the system may
damage the product.
Fluid
Inlet Air Out Blood
Inlet Activate
Filling
Fluid Inlet
Air Out Blood
Inlet Activate
Filling
SimMan
Blood Fill Uni t
SimMan
Blood Fill Unit
Fluid
Inlet Air Out Blood Inlet Activate Filling
Fluid Inlet
Air Out Blood Inlet Activate Filling
SimMan
Blood Fill Uni t
SimMan
Blood Fill Unit
Fluid
Inlet
Air Out Blood
Inlet Activate
Filling
Fluid
Inlet
Air Out Blood
Inlet Activate
Filling
SimMan
Blood Fill Uni t
SimMan
Blood Fill Unit
Fluid
Inlet Air Out Blood
Inlet Activate
Filling
Fluid
Inlet
Air Out Blood
Inlet Activate
Filling
SimMan
Blood Fill Uni t
SimMan
Blood Fill Unit
Fluid
Inlet Air Out Blood Inlet Activate Filling
Fluid Inlet
Air Out Blood Inlet Activate Filling
SimMan
Blood Fill Uni t
SimMan
Blood Fill Unit
Fluid
Inlet
Air Out Blood
Inlet Activate
Filling
Fluid
Inlet
Air Out Blood
Inlet Activate
Filling
SimMan
Blood Fill Uni t
SimMan
Blood Fill Unit