Troubleshooting, Lungs, Mechanical noise during auscultation – Laerdal SimMan 3G Trauma User Manual

Page 44: Batteries, Pulses, Clinical features - pneumothorax bladders, Simulator shut down

Advertising
background image

Lungs

Problem

– Lungs not functioning properly.

Possible Solution

– Check that the airway resistance is not set to maximum in

LLEAP.

– Open the torso and Chest Plate. Check that the lungs are free

to expand and are not restricted by any cables.

– Check that the Lung Bladders are properly connected, and that

the tubes are not twisted.

– Check that the Lung Bladders are in a horizontal position and

inserted correctly. Ensure that the lung compliance O-rings lie
between the folds of the Lung Bladders.

– Check for flaws or ruptures in the Lung Bladders.

– Check that the two lung compliance O-rings are fitted correctly.

Replace O-rings if they appear to be damaged.

– Check that there are no obstructions inside the simulator

airways which may block air flow.

– If there is no change when adjusting lung compliance, contact

Laerdal Technical Service.

– If there is no change in lung resistance, contact Laerdal Technical

Service.

Mechanical Noise during Auscultation

In LLEAP, click <auscultation focus>.

Batteries

Problem

– Battery life is less than 150 minutes with healthy patient and fully

charged batteries.

Possible Solutions

– Batteries may be old, (recommended lifetime is 200 discharge

cycles). Insert new batteries.

– Compressor may not function properly; consult your local

Laerdal Technical Services Centre.

Pulses

Problem

– Cannot feel pedal pulses

Possible Solutions

– Skin may be too tight over pulse units – readjust skin and reboot.

Clinical Features - Pneumothorax Bladders

Problem

– Experience problems with Pneumothorax Bladders.

Solution

– Check tubing connection at base of the bladder, to ensure that

tubing has not been disconnected.

Simulator Shut down

Problem

– The Patient Simulator is unresponsive.

Solution

Press and hold the <ON/OFF> button for 10 seconds to force the
Patient Simulator to shut down.

TROUBLESHOOTING

Advertising