LINK Systems OmniLink II Press Automation Control - Manual (Page 103)

August 30, 2002 Manual Version 1.0 5.20
Section 5.6.2 Recall Setup
From the Jobs Menu, Figure 5.9, pressing the RECALL SETUP softkey will either transfer the screen to
the Select Jobs menu, or initiate the user password sequence which accesses the Select Jobs menu,
depending on the Key/Code Access Mode configured. If the user obtains access control by using the
password system, the user must be configured to have permission to recall jobs from memory. The
Select Job screen allows the user to select the job that is to be recalled. The Select Job menu is shown in
Figure 5.11. There are two ways to select a job. The first way is to enter the job number, if it is known.
The ENTER NUMBER softkey allows the user to enter the desired job number directly into the operator
terminal, which automatically searches the file system and retrieves the job if located. The second way
is to select the job from the screen. Select a job by using the NEXT GROUP key to locate the page that
the job is on, and then using the arrow keys to position the cursor on the correct job. With the cursor on
the correct job, depress the SELECT softkey.
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed SPM
SPM
0
0 Order
Counter
PC STATUS
Counter OFF
SELECT
JOB
SELECT
EXIT
0 0
PROGRAM/RUN SWITCH TOP
NEXT
GROUP
ENTER
NUMBER
JOB NUMBER DESCRIPTION
000000001 FIRST EXAMPLE
000000002 SECOND EXAMPLE
000000003 THIRD EXAMPLE
000000004 FOURTH EXAMPLE
000000005 FIFTH EXAMPLE
000000006 SIXTH EXAMPLE
000000007 SEVENTH EXAMPLE
000000008 EIGHTH EXAMPLE
000000009 NINTH EXAMPLE
000000010 TENTH EXAMPLE
000000011 ELEVENTH EXAMPLE
000000012 TWELTH EXAMPLE
000000013 THIRTEENTH EXAMPLE
000000014 FOURTEENTH EXAMPLE
123456789 TWENTY CHARACTERS
Figure 5.11 Select Jobs Screen
Either method of locating the desired job results in a request for final verification as shown in Figure
5.12. After verifying that the job number and description are correct, the RECALL SETUP softkey
replaces the information in the current job with that of the requested one. During the recall process, the
message "Loading the Job" is displayed. When complete, the operator terminal returns to the job setups
menu and the current job information reflects the change.
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0 Order
Counter
PC STATUS
Counter OFF
RECALL
JOB
EXIT
0 0
PROGRAM/RUN SWITCH TOP
RECALL
SETUP
You Have Selected to RECALL:
Job Number Description
000000001 FIRST EXAMPLE
WARNING! Always check to make certain that you are
recalling the correct setup. Recalling an incorrect
setup for a production process can result in bodily
injury and/or damage to machine or tooling.
RECALL SETUP when ready.
Figure 5.12 Recall Jobs Screen