LINK Systems OmniLink II Press Automation Control - Manual (Page 104)

August 30, 2002 Manual Version 1.0 5.21
Section 5.6.3 Erase Setup
From the Jobs Menu, Figure 5.9, pressing the RECALL SETUP softkey will either transfer the screen to
the Select Jobs menu (Figure 5.11), or initiate the user password sequence which accesses the Select
Jobs menu, depending on the Key/Code Access Mode configured. If the user obtains access control by
using the password system, the user must be configured to have permission to erase jobs from memory.
The Select Job menu allows the user to select the job that is to be erased. Once a job is selected the
Erase Jobs screen (similar to the Recall Jobs screen of Figure 5.12 except the softkey legend is ERASE
JOB) appears.
The method for locating a job is the same as those for recalling one. Once the job to be erased has been
located, the ERASE SETUP softkey can be used to erase the job.