LINK Systems OmniLink II Press Automation Control - Manual (Page 55)

August 30, 2002 Manual Version 1.0 4.6
If the CONFIGURE softkey is pressed, the display will ask for the configuration code. This user
configuration code is user programmable and is the highest order user password for the system. An
original code is sent from the factory to a person designated when the control is ordered. The user has
the option of keeping the original code or changing to another during the initial configuration or at a
later time if desired. This user configuration code is used to access the Main Configuration menu, as
well as all other configuration menus and must be provided to qualified personnel only. When the code
is entered, the Main Configuration Menu shown in Figure 4.5 appears.
Figure 4.5 Main Configuration Menu
The Main Configuration menu presents a list of other submenus that may be selected by softkey to enter
settings for parameters. Once access to the Main Configuration menus is obtained, the Program/Run
switch may be switched back and forth between PROG and RUN. It will be necessary to switch back to
the Run position and stroke the press for certain Main Configuration Menu calibrations that may be
required, as discussed in later sections. Also, some of the Run Mode and Program Mode screens will be
available from certain Configuration Mode menus to aid in calibration or settings. The configuration
mode will remain in effect until manually exited by pressing the EXIT softkey repetitively until the
display returns to the Brake Monitor menu.
Settings can only be made in the configuration mode with the Program/Run switch turned to
PROG. The arrow keys are used to position the cursor onto the configuration setting to be changed.
Stroke
Mode
Drive
Speed
Stroke
Speed
SPM
SPM
0
0 Order
Counter
SYSTEM STATUS
Counter OFF
0 0
OK
TOP
Main
Config
TOP STOP
CALIBRATE
MACHINE
PARAMETERS
OPERATOR
TERMINAL
EXIT
Top Stop Calibration
Machine Parameters
Operator Terminal
Exit Configuration
Names and Messages
NAMES