LINK Systems OmniLink II Press Automation Control - Manual (Page 30)

August 30, 2002 Manual Version 1.0 2.21
Section 2.4 Additional Mounting and Wiring if the Operator Terminal, R/D-Brake
Monitor Module, and (Optionally) Solid State Relay Module are Provided
Without Enclosure for Customer Panel Mounting
The OmniLink II Press Automation Control base system package may be purchased without the operator
terminal, R/D-Brake Monitor module, and (optionally) Solid State Relay Module already mounted and
pre-wired inside an Operator Terminal enclosure. This allows the customer to install the basic
components of the system into his own enclosure(s). When this is the case, the customer will need to
perform the additional component mounting and wiring.
Section 2.4.1 Mounting the Base Components in the Customer Enclosure
Mount the OmniLink II LCD Operator Terminal in an enclosure with viewing angle considerations as
shown in Figure 2.4 and with clearance to easily operate the membrane keys on the terminal. Figure 2.19
shows the mounting hole dimensions of the operator terminal. The R/D-Brake Monitor module should
be mounted on the inside of the enclosure on which the operator terminal is mounted. When furnished
for customer panel mount, it will be come mounted on an intermediate fixture that aids customer
mounting. See mounting dimensions in Figure 2.20. Similarly, if the optional 4-channel Output Relay
Module is provided, this should be mounted on the inside of the enclosure on which the operator
terminal is mounted. Mounting Dimensions
Figure 2.19 OmniLink II LCD Operator Terminal Mounting Dimensions