LINK Systems OmniLink II Press Automation Control - Manual (Page 46)

August 30, 2002 Manual Version 1.0 3.13
Figure 3.11 User Selection Box Appears on Die Protection Configuration Screen
Figure 3.12 User Name Code Entry Box on the Die Protection Configuration Screen
After entry of a valid access code, the popup table and code entry box will disappear and the Program
Mode screen of Figure 3.13 will appear, allowing settings to be made. The user will have access to all
restricted items, including settings and actions for functions other than die protection that have been
designated for his access in the configuration mode.
Stroke
Mode
Drive
Speed
Stroke
Speed
SPM
SPM
0
0 Order
Counter
SYSTEM STATUS
Counter OFF
DP Chan
Config
SELECT
0 0
OK TOP
EXIT
0
90 270
180
Die Prot. Channel Configuration Module: 1 Channel: 5
Channel Type:
Descript
Input T
Stop T
Bypass
Delay Ti
Delay Stro
Window
Window
Cyclic
Help
Sets the type of Logic
to apply to the
channel
Cyclic - Norm. OFF
Used to monitor events that occur
once per machine cycle. The input
must be ON somewhere in the timing
window AND OFF somewhere in the
timing window.
Select a User Name
John
Jane
Ed
Sam
Joe
Ted
SoftKeys
Press Select after using
Use Up/Down arrow
keys to highlight your
user name in list
DP Chan
Settings
Stroke
Mode
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
SYS TEM STATUS
Counter OFF
DP Chan
Config
CHANGE
SETTING
0 0
OK TO P
EXIT
0
90 270
180
Die Prot. Channel Configuration Module: 1 Channel: 5
Channel Type:
Description:
Input Type:
Stop Type:
Cyclic
Lef t Front St ripper
Normally O FF
Top Stop
No
0 msecs
0 Strokes
154 0
213 0
He lp
Set s the type of L ogic
Cyclic - Norm. OFF
Used t o monitor events that occur
once per machine cycle. The input
must be ON somewhere in t he timing
window AND OFF somewher e in the
timing window.
Select a User Name
JOHN CO DE:
SoftKeys
Enter the code
(Pasword)for
John
DP Chan
Settings