LINK Systems OmniLink II Press Automation Control - Manual (Page 51)

August 30, 2002 Manual Version 1.0 4.2
The Device Configuration menu is also used to update the software in the various modules used
with the system when needed or desired, although this normally will not need to be done when you
initially configure your system. The OmniLink II Operator Terminal provides for the insertion of a
smart media card with updated software to download to the various modules used with the system.
The Device Configuration Menu is accessed from the Quick Access screen shown in Figure 4.1.
Pressing the ACC key on the operator terminal keypad causes the Quick Access screen to be displayed.
Figure 4.1 The Quick Access Screen with Program/Run Switch in Program
The DEVICE CONFIG softkey in the lower left corner of the screen appears only with the Run/Program
switch in the program position. Pressing the DEVICE CONFIG softkey causes a box to popup which
requests that you enter the User Configuration Code, the highest order user password. After entry of the
correct code, the first page of the Device Configuration screen, shown in Figure 4.2, is displayed.
Figure 4.2 Device Configuration Screen, First Page.
Stroke
Mode
Drive
Speed
Stroke
Speed
SPM
SPM
0
0 Order
Counter
SYSTEM STATUS
Counter OFF
0 0
OK
TOP
Quick
Access
EDIT
NOTES
EXIT
AUXILIARY
COMM.
Current Login: None
MACHINE NOTES
LOGOUT DEVICE
CONFIG
NOTES FOR JOB #
Stroke
Mode
Drive
Speed
Stroke
Speed
SPM
SPM
0
0 Order
Counter
SYSTEM STATUS
Counter OFF
0 0
OK
TOP
Device
Config
TOGGLE
USED
UPDATE
PROGRAM
EXIT
NEXT
PAGE
Device Configuration
Device Used Status
System 5000 Card Rack
System 5000 Comm Module
R/D - Brake Monitor Module
Prog. Limit Switch (1-8)
Prog. Limit Switch (9-16)
Prog. Limit Switch (17-24)
Prog. Limit Switch (25-32)
No
No
Yes
Yes
Yes
No
No
Hardware Detected :
Hardware Version :
Bootcode Version :
Software Version :
Avail. Version :