Rocktron Chameleon On-Line - Manual (Page 83)

80
Program Changes
Program Changes allow for different MIDI program numbers to be assigned to Chameleon preset numbers. For
example, MIDI program #58 can be mapped to Chameleon preset #34. Then, when program #58 is selected from a MIDI
transmitting device (such as a Rocktron All Access
® foot controller), preset #34 will be recalled on the Chameleon.
The Program Changes Map table is shipped from Rocktron at a one-to-one correspondence (i.e. MIDI program #1 is
mapped to Chameleon preset #1, 2 to 2, 3 to 3, etc.).
3,7 4,8 2,5,6 1
To access MIDI Program Mapping, turn the FUNCTION SELECT control clockwise until the
Chameleon displays "PROGRAM CHANGES". Step 1
Turn the PARAMETER SELECT control one step clockwise to display the current Program Change
On/Map/Off status. Step 2
Turn the PARAMETER ADJUST control to select the desired Program Changes status setting. Step 3
PROGRAM CHANGES
PROG CHANGES ON
PROG CHANGES MAP
Step 4 Press the STORE button to save the status selection. "STORED" will flash briefly on the display.
Program Changes status options
ON - Execute MlDI program changes as received by a MIDI controller
MAP - Use mapping table when a program change is received
OFF - Do not execute MlDI program changes
STORED