Rocktron Chameleon On-Line - Manual (Page 96)

93
FUNCTION SELECT control to exit this function.
Press the STORE button at this time to initiate the All Restore procedure and erase all current
Chameleon presets, replacing them with the original factory presets. The Chameleon will display
"INITIALIZING" as the Chameleon memory is restored.
After the All Restore process is completed, the display should read "ERRORS 0". This is the number
of bytes that the Chameleon found that did not initialize properly. Any number of errors other than "0"
Step 4
INITIALIZING
means that the Chameleon may not have initialized properly and the process should be repeated.
The Chameleon will remain in this condition until the FUNCTION SELECT control is turned to exit the Factory Restore
function. The preset currently recalled will be the preset most recently restored into the current location.
ERRORS 0
The controller assignments for the Chameleon can also be reinitialized without affecting presets and other stored
information. Reinitialization of the controller assignments is necessary when setting up the Chameleon to operate in remote
mode with a Rocktron All Access
® footswitch.
To reinitialize only the controller assignments, enter a code number of "244" at Step 3 above.
Restoring the Chameleon controller assignments: