Rocktron Chameleon On-Line - Manual (Page 92)

89
Notes:
If errors occur during transmission, the unit will display "RECEIVE ERROR " for transmission errors and
"XMEM ERROR" for internal hardware errors. Errors occurring in transmission does not indicate that all
of the received data is corrupted. Only the transmission string where the error occurred is corrupted.
When receiving a Bulk Load, it is important that the data loaded to the Chameleon is not transmitted faster
than it was originally dumped from the Chameleon. If information is sent too fast to the Chameleon, an error
will occur.
When dumping information from a data storage device, such as an Alesis Data Disk, it is necessary to
perform the dump in sequence mode rather than sysx mode. Sequence mode will dump the information back
to the Chameleon at the same rate as it was received from the Chameleon. The Chameleon can receive a
data dump at about 65Hz (or about 1 byte every 15 milliseconds).
Step 4 LOAD" is displayed.
Play back the data stored on the sequencer. The Chameleon will display the data strings as it is
storing them. Each data string will appear with the word "LOADED". After all the user data has
been loaded, the Chameleon will display "LOAD COMPLETE". Do not play back the data
from the sequencer faster than it was loaded, as errors may occur (errors may also occur if any
knob is turned or any button is pressed before the message "LOAD COMPLETE" appears).
LOAD COMPLETE