Datalogic Scanning 4420 - Manual (Page 82)

Networks, Communications, and Connections
4-4 Falcon
®
4400 Series with Windows
®
CE
Setting Up ActiveSync
1. Open ActiveSync from the System Tray of the Host PC.
2. Connect the Falcon to the Host PC via a dock or USB/Serial cable.
3. Verify that the Falcon is turned on.
4. Within a minute, the ActiveSync window should appear, attempting
to connect to a new device.
Figure 4-4. Microsoft ActiveSync dialog
5. If ActiveSync does not connect within two minutes, try the following:
• Double-click and open ActiveSync from the Host PC’s System
Tray if it is not already open.
• Remove the Falcon from the dock and then reinsert it into the
dock or disconnect the cable from the Host PC and reconnect it.
• Select File > Get Connected for ActiveSync to look for a mobile
device.
• Go to File > Connection Settings and make sure that your Connec-
tion Settings dialog show the same selections as that in Figure 4-5
below if you have a USB connection. If you have a serial connec-
tion, select the correct COM port from the pull-down list.