Pilz PSSu E S 2DO 2-T - Manual (Page 25)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-1
6.1 General wiring guidelines
6 Wiring
6 6000 Wiring Wiring 6- 6.1 General wiring guidelines 6100 General wiring guidelines 6- ][Verdrahtung BA Einleitung
Please note:
][Verdrahtung ST-Ausgang  The actuators may be connected using unshielded cables.
 The outputs do not need suppression for inductive loads.
 Use copper wiring.
][Verdrahtung Zusatz mit C  The terminal configuration as stated on the front plate applies for base
modules with C-rail. The terminal configuration as stated in the tech-
nical documentation applies for all other base modules.
6.1.1 Mechanical connection of the base modules
Mechanical connection of the base modules 6- ][Modulverdrahtung mech
Procedure:
 Use a flat blade screwdriver (DIN 5264-A)!
 Strip the wire back 8 mm.
 If necessary, label the connection level with a colour marker [3].
 Base module with screw terminals:
– Use a screwdriver to loosen the screw on the screw terminal [1]
– Insert the stripped cable into the round fixing hole [2], as far as it
will go.
– Tighten up the screw on the screw terminal.
– Check that the cable is firmly seated.
 Base module with cage clamp terminals:
– Insert the screwdriver [4] into the square hole [1].
– Insert the stripped cable into the round fixing hole [2], as far as it
will go [5].
– Pull out the screwdriver [6].
– Check that the cable is firmly seated.
DIN 5264-A
21 11
[1]
[3]
[2]