Pilz PSSu E S 2DO 2-T - Manual (Page 29)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-1
7.1 Messages
7 Operation
7 7000 Operation Operation 7- 7.1 Messages 7100 Messages 7- ][BA_Betrieb Störung LED "Err" Sys A + B
A module error is displayed via the "Err" LED (see section entitled "Dis-
play elements"), signalled to the head module and then entered in the
head module's
 Error stack, with PSSu in system environment A
 Diagnostic log, with PSSu in system environment B.
][BA_Betrieb Fehler ST
The module can detect the following errors:
Module error Explanation Remedy
Start-up error Error as the PSSu system starts up. Change faulty module.
Configuration error Incorrect module type configured. The configured hardware registry does
not match the actual hardware regis-
try.
ST communication error Error in ST communication with the
head module. Change faulty module.
Bus termination error There is no end bracket. Install a terminating plate with inte-
grated end angle.