Pilz PSSu E S 2DO 2-T - Manual (Page 5)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
1-1
1.1 Validity of documentation
1 Introduction
1 1000 Introduction Introduction 1- 1.1 Validity of documentation 1100 Validity of documentation 1- ][BA Einf Gültigkeit_(T)
This documentation is valid for the products PSSu E S 2DO 2 and
PSSu E S 2DO 2-T. It is valid until new documentation is published.
Einf Einleitung
This operating manual explains the function and operation, describes
the installation and provides guidelines on how to connect the product .
1.1.1 Retaining the documentation
Retaining the documentation 1- Einf Aufbewahren
This documentation is intended for instruction and should be retained
for future reference.
1.1.2 Terminology: System environment A and B
Terminology: System environment A and B 1- ][BA Einf Begriffsdefinition Sys A + B
The PSSu system can be used in two different system environments.
The module's application area is described in the chapter "Intended
Use" of the manual.
The distinction is made between
 PSSu in system environment A
 PSSu in system environment B
The distinction is based on the application area of the PSSu system.
PSSu in system environment A may be used in the
 Decentralised system PSSu I/O with SafetyBUS p
 Decentralised system PSSu I/O with ST fieldbuses such as CANopen,
DeviceNet
 Not in the automation system PSS 4000
PSSu in system environment B may be used in the
 Automation system PSS 4000, e.g. with the
– Decentralised system PSSu I/O with SafetyNET p
– Control system PSSu PLC
– Control system PSSu multi