Lenco L-90 - Manual (Page 6)

6
Basic operation
Playing records
Switch the main power switch on the backside of the turntable to the “on” position.
Open the dust cover and place the record on the platter. If you play a single, do not
forget to place the single puck first.
Set the correct RPM speed
Remove the needle protection cover from the stylus
Unlock the tone arm on the armrest
Bring the tone arm to the record, the platter now starts rotating
Carefully place the tone arm on the record. Do not forget to lower the arm lever
If you want to interrupt a record during playing, raise the arm lever. Alternatively,
return it to the armrest to stop the record playing. When a record has come to its end,
the platter stops rotating*.
*Auto-stop should be on.
Connect the turntable to a computer for the first time
As this turntable is plug-and-play, no drivers are needed.
Before you connect the turntable to a computer, unplug it from
your mixer or Hi-Fi system.
The included software is a third party application and therefore
Lenco does not handle any questions or problems regarding the
software.
1. Switch the computer on
2. Connect the turntable to an AC wall outlet
3. Place the main power switch on the back side of the turntable in the “on” position
4. If the computer is booted, connect the turntable. The computer will now install the
drivers.
5. After the drivers are installed, you must now install the Audacity software.
For windows users; insert the CD or download the newest software via
http://audacity.sourceforge.net
For MAC users; download the newest software via
http://audacity.sourceforge.net
Important: Make sure that your computer recognizes the turntable as a recording
device. Especially Windows has the tendency to set the turntable default as a playing
device. If the turntable is set as playing device, Audacity cannot record your records.
Software Configuration (Windows XP, Vista, MAC)
1. Connect the turntable to the computer.
Note: Before connecting the turntable to the PC, disconnect the turntable from
your audio-system.
2. Start the Audacity software
3. Click on Microphone in the drop down menu and select “Stereo Mix”