Subaru 2009 Legacy - Manual (Page 138)

Black plate (141,1)
北米Model "A2450BE-A" EDITED: 2008/ 3/ 24
& Clock (vehicle with genuine
SUBARU navigation system)
The clock receives the correct time from
the navigation system. To adjust the time
shown by the clock, refer to the Owner
’s
Manual supplement for the monitor sys-
tem and adjust the time of the navigation
system.
CAUTION
To ensure safety, do not attempt to
set the time during driving, as an
accident could result.
& SI-DRIVE display
1) Sport Sharp (S#) mode
2) Sport (S) mode
3) Intelligent (I) mode
4) Throttle angle
*: This display means that the Sport Sharp
(S#) mode is in the selected condition.
This display indicates the current SI-
DRIVE mode with its throttle angle.
For details of SI-DRIVE mode, refer to the
“SI-DRIVE (turbo and 3.0 L models)”
section in chapter 7.
& Meter settings
The following items can be set or regis-
tered on the multi-information display as
desired.
. Initial movements of the meter/gauge
needles
. Present date & time
. Birthday
. Anniversary
Within 12 seconds after turning on the
ignition switch, press the
“ /SET” switch
for at least 2 seconds.
The display can be switched as shown
below by pressing the
“ ” or “ ” switch.
*: “Present date & time”, “Birthday” and
“Anniversary” can be registered in the
“Date/Time” setting menu.
Refer to the following procedure for further
steps.
! Initial movement setting
It is possible to activate or deactivate the
initial movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the
“ON”
position.
Instruments and controls
3-15
– CONTINUED –
3