Subaru 2009 Legacy - Manual (Page 176)

Black plate (179,1)
北米Model "A2450BE-A" EDITED: 2008/ 3/ 24
& Rear window wiper and
washer switch (Station wa-
gon)
: Washer (accompanied by wiper operation)
ON: Continuous
INT: Intermittent
OFF: Park
: Washer
! Rear wiper
To turn the rear wiper on, turn the knob on
the end of the wiper control lever upward
to the
“INT” or “ON” position.
To turn the wiper off, return the knob on
the end of the lever to the
“OFF” position.
With the switch turned to the “INT”
position, the rear wiper will operate inter-
mittently at intervals corresponding to the
vehicle speed.
When you subsequently move the selec-
tor lever of the automatic transmission to
the
“R” position, the rear wiper will switch
to continuous operation. When you move
the selector lever from the
“R” position to
some other position, the rear wiper will
return to intermittent operation.
! Washer
To wash the rear window while the rear
wiper is operating, turn the knob on the
end of the wiper control lever upward to
the
“ ” position. The washer fluid sprays
until you release the knob.
To wash the rear window when the rear
wiper is not in use, turn the knob on the
end of the wiper control lever downward to
the
“ ” position. The washer fluid sprays
and the wiper operates until you release
the knob.
Windshield wiper deicer
(if equipped)
The windshield wiper deicer operates only
when the ignition switch is in the
“ON”
position.
Before turning on the windshield wiper
deicer, remove any snow from the wind-
shield. To turn on the windshield wiper
deicer, push the button. The indicator light
located on the button lights up while the
windshield wiper deicer is operating.
The windshield wiper deicer will automa-
tically shut off after approximately 15
minutes. If the windshield wiper blades
have been deiced completely before that
time, push the button to turn it off. It also
turns off when the ignition switch is turned
Instruments and controls
3-53
– CONTINUED –
3