Subaru 2009 Legacy - Manual (Page 273)

Black plate (281,1)
北米Model "A2450BE-A" EDITED: 2008/ 3/ 24
tional, it prevents the selector lever from
being moved from the
“N” position to the
“R” position. When the vehicle speed
drops below 6 mph (10 km/h), the function
is canceled. The selector lever can then
be moved to the
“R” and “P” positions.
When the ignition switch has been turned
to the
“LOCK” position, movement of the
selector lever from the “N” position to the
“R” position is possible for a limited time
period by depressing the brake pedal and
then becomes impossible. Also, the se-
lector lever cannot be moved to the
“R”
position after it has been placed in the “P”
position and then placed again in the “N”
position.
When the movement of the selector lever
from the
“N” position to the “R” position
has become impossible, turn the ignition
switch back to the
“ON” position then
move the selector lever to the “P” position.
Pressing the selector lever release button
also makes it possible to move the
selector lever to the
“P” position at this
time.
! Selector lever release button
If you inadvertently have turned the igni-
tion switch to the
“LOCK” position with the
selector lever in the “N” position, proceed
as follows. By referring to the “Shift lock
release ” section in this chapter, remove
the shift lock release cover. Then, with the
screwdriver inserted into the hole, move
the selector lever to the
“P” position. If the
selector lever reverse inhibiting function
fails, have the vehicle inspected by the
nearest SUBARU dealer.
& Selection of manual mode
With the vehicle either moving or station-
ary, move the selector lever from the
“D”
position to the manual gate to select the
manual mode.
Starting and operating
7-27
– CONTINUED –
7