Subaru 2009 Legacy - Manual (Page 192)

Black plate (196,1)
北米Model "A2450BE-A" EDITED: 2008/ 3/ 24
4-10
Climate control
! A/C – Air conditioner button
If the windshield starts to fog when the
climate control system is operated in the
AUTO mode, push the air conditioner
button
“A/C” to defog and dehumidify.
When this button is pushed, the air
conditioner compressor turns on and the
indicator light
“A/C” on the display illumi-
nates. After eliminating the fogging from
the windshield, set the system back to the
AUTO mode by pushing the
“AUTO”
button.
NOTE
The air conditioner compressor does
not operate when the outside air tem-
perature is below 32
8F (08C).
! Air flow mode selection button
Select the desired air flow mode by
pushing the air flow mode selection
button. The selected air flow mode is
shown by the display.
(Ventilation): Air flows through the
instrument panel outlets.
(Bi-level): Air flows through the instru-
ment panel outlets and the foot outlets.
(Heat): Air flows through the instrument
panel outlets, the foot outlets, and some
through the windshield defroster outlets.
(Heat-def): Air flows through the instru-
ment panel outlets, the windshield defros-
ter outlets, and the foot outlets.
! Air inlet selection button
Select air flow by pushing the air inlet
selection button
“ / ”.
The selected air inlet setting is shown on
the control panel.
(Recirculation): Interior air recirculates
inside the passenger compartment. Use
this position when quickly cooling down
the passenger compartment or to prevent
outside air from entering the passenger
compartment. When the recirculation
mode is selected, a
“ ” indicator light
appears on the display.
(Outside air): Outside air is drawn into
the passenger compartment. When the
climate control system is operated in the
“AUTO” mode, this position is selected
automatically. (There is one exception: