Operating fireplace, Installation – Desa FPVF33PRA User Manual

Page 19

Advertising
background image

www.desatech.com

113109-01C

19

INSTALLATION

Continued

INSTALLING 9-vOLT BATTERIES

Two 9-volt batteries (not included) are required

to operate this heater with the wireless hand

held remote control set. Install one battery in the

receiver and one in the hand-held remote control

unit. Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver

1. Locate back of receiver under front burner of

heater.

2. Locate the battery clip mounted on the back

of the receiver.

3. Slide a 9-volt battery through the clip.

4. Attach the terminal wires to the battery.

Figure 36 - Installing Battery in Remote

Receiver

Battery Clip

9-Volt Battery

Remote
Receiver

Figure 37 - Installing Battery in Hand-

Held Remote Control Unit

Battery
Cover

Terminal
Wires

Remote
Control
Unit

9-Volt
Battery

Battery
Housing

Terminal Wires

Installing 9-Volt Battery in Hand-Held
Remote Control Unit

1. Remove battery cover on back of remote

control unit.

2. Attach terminal wires to the battery. Place

battery into the battery housing.

3. Replace battery cover onto remote control unit.

OPERATING FIREPLACE

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,

a fire or explosion may result

causing property damage, per-

sonal injury or loss of life.

A. This appliance has a pilot which must be

lighted by hand. When lighting the pilot,

follow these instructions exactly.

B. BEFORE LIGHTING smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not

use any phone in your building.

• Immediately call your gas supplier

from a neighbor’s phone. Follow the

gas supplier’s instructions.

• If you cannot reach your gas supplier,

call the fire department.

C. Use only your hand to push in or turn the

gas control knob. Never use tools. If the

knob will not push in or turn by hand, don’t

try to repair it, call a qualified service tech-

nician or gas supplier. Force or attempted

repair may result in a fire or explosion.

D. Do not use this appliance if any part has

been under water. Immediately call a

qualified service technician to inspect the

appliance and to replace any part of the

control system and any gas control which

has been under water.

Advertising