Local codes, Unpacking, Product features – Desa FPVF33PRA User Manual

Page 5: Air for combustion and ventilation

Advertising
background image

www.desatech.com

113109-01C

5

LOCAL CODES

Install and use fireplace with care. Follow all local

codes. In the absence of local codes, use the lat-

est edition of The National Fuel Gas Code, ANSI

Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

UNPACkING

CAUTION: Do not remove the

data plates attached to the heater

base assembly. The data plates

contain important warranty and

safety information.

1. With utility knife, cut the carton all the way

around above the staples on the bottom tray.

Lift the carton off the heater. Remove packing.

Note:

The hood is located in the packing on

the right hand side of the heater front. Lift the

heater off the bottom tray.

2. Locate two screws above top corners of the

fireplace screen. Remove and discard these

screws. Lift fireplace screen up and pull out

to remove.

3. Remove protective packaging applied to logs,

log base assembly and fireplace.

4. Remove fireplace hood from carton insert.

5. Check all items for any shipping damage. If

damaged, promptly inform dealer where you

bought fireplace.

PRODUCT FEATURES

OpERATION

This vent-free fireplace is clean burning. It requires

no outside venting. There is no heat loss out a

vent or up a chimney. Heat is generated by both

realistic flames. When used without the blower, the

fireplace requires no electricity making it ideal for

emergency backup heat. This heater is designed

for vent-free operation. It has been tested and ap-

proved to ANSI Z21.11.2 standard for unvented

heaters. State and local codes in some areas pro-

hibit the use of vent-free heaters.

SAFETY DEvICE

This fireplace has a pilot with an Oxygen Depletion

Sensing (ODS) safety shutoff system. The ODS/

pilot is a required feature for vent-free room heat-

ers. The ODS/pilot system shuts off the fireplace

if there is not enough fresh air.

pIEzO IGNITION SYSTEM

This fireplace has a piezo ignitor. This system

requires no matches, batteries or other sources to

light fireplace.

OpTIONAL REMOTE CONTROL UNITS

There are four optional remote controls that can be

purchased separately for this log heater:

• wall switch

• wall thermostat

• hand-held ON/OFF remote

• hand-held thermostat remote

See Accessories, page 38.

OpTIONAL BLOWER ASSEMBLY
(GA3700 SERIES & GA3700T
SERIES)

This fireplace accepts an optional blower assembly

(not included). The GA3700T Series blower oper-

ates thermostatically and features a variable speed

control. The GA3700 Series blower operates man-

ually and also features a variable speed control.

The blower circulates heated air from the fireplace

into the room. See Accessories, page 38.

AIR FOR COMbUSTION

AND VENTILATION

WARNING: This heater shall

not be installed in a confined

space or unusually tight construc-

tion unless provisions are provid-

ed for adequate combustion and

ventilation air. Read the following

instructions to insure proper fresh

air for this and other fuel-burning

appliances in your home.

Today’s homes are built more energy efficient

than ever. New materials, increased insulation and

new construction methods help reduce heat loss

in homes. Home owners weather strip and caulk

around windows and doors to keep the cold air out

and the warm air in. During heating months, home

owners want their homes as airtight as possible.

Advertising