Desa FPVF33PRA - Manual (Page 21)

www.desatech.com 113109-01C 1
OPERATING FIREPLACE
Continued
WARNING: Make sure the
selector switch is in the OFF
position when you are away from
home for long periods of time.
Fireplace will come on automati-
cally with selector switch in the
ON position.
TO TURN OFF GAS
TO AppLIANCE
Shutting Off Fireplace
1. Turn control knob clockwise to the
OFF position.
2a. Set selector switch in the OFF position.
2b. If Using Optional Hand-Held Remote: Set
selector switch in the OFF position to keep
from draining the battery.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burner and keep the pilot
lit by doing one of the following:
• Turn control knob clockwise to the
PILOT position.
• Use remote control manual OFF button.
• Set selector switch in the OFF position.
MANUAL LIGHTING
pROCEDURE
1. Follow steps 1 through 6 under Lighting
Instructions, page 20.
2. Press control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through
11 under Lighting Instructions, page 20.
OpTIONAL HAND-HELD
REMOTE OpERATION
Note: All remote control accessories must be
purchased separately (see Accessories, page
38). Follow instructions included with the
remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 20 .
After lighting, let pilot flame burn for about one
minute. Turn control knob to ON position. Adjust
flame adjustment knob anywhere between HI and
LO. Slide the selector switch to the REMOTE
position (see Figure 41). Note: The burner may
light if hand-held remote was on when selector
switch was last turned off. You can now turn the
burner on and off with the hand-held remote
control unit.
IMPORTANT:
Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
O
FF
PILO
T
ON
L O
IH
AUTO
ON
OFF
Figure 41 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
Selector Switch in Remote
Position (Optional Hand-
Held Remote Control)
Control Knob
in On Position
Flame Adjustment Knob
Figure 42 - On/Off Hand-Held Remote
Control Unit (HRC100)
Control
Button Turns
Burners On
and Off
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 42).
TO LOCK
press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK
press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.