Applied Motion ST10-Plus - Manual (Page 33)

33
ST5/10-S Hardware manual 920-0027 Rev. D
2/7/14
Mechanical Outline
Mounting the Drive
You can mount your drive on the wide or the narrow side of the chassis using #6 screws. If possible, the drive
should be securely fastened to a smooth, flat metal surface that will help conduct heat away from the chassis. If
this is not possible, then forced airflow from a fan may be required to prevent the drive from overheating.
• Never use your drive in a space where there is no air flow or where other devices
cause the surrounding air to be more than 40°C.
• Never put the drive where it can get wet or where metal or other electrically conduc-
tive particles can get on the circuitry.
• Always provide air flow around the drive. When mounting multiple ST drives near
each other, maintain at least one half inch of space between drives.
3.0
3.65
1.125
6X SLOT 0.16
WIDE, FULL R
1.98
0.61
0.663
3.39